TC1034

2 CAN FD / FlexRay to USB interface

TC1034 is operated through TSMaster software, allowing multiple TC1034 devices to be used in parallel or to work together with other FlexRay products from the same company. When used with CAN, LIN, or automotive Ethernet interface tools from the same manufacturer, the TC1034 enables a single PC to perform high-performance multi-bus analysis and simulation. It is suitable for use by developers, testers, ECU production lines, and test engineers.

Primary functions of FlexRay

  • The communication controller buffer can be flexibly configured
  • Can detect empty frames
  • Supports composite communication modes composed of multiple cycles (Cycle multiplexing)
  • Supports frame payloads up to 254 bytes
  • Supports PDUs (Protocol Data Units)
  • Has startup monitoring function
  • Supports FlexRay message logging and playback
  • The two FlexRay channels can be used in parallel as two FlexRay nodes
    • Support for both CAN FD and FlexRay with hardware timestamping
    • High-speed USB 2.0 interface
    • Driver-free installation for Windows systems
    • Built-in 120Ω resistor for CAN and 100Ω for FlexRay (software configurable)
    • CAN FD support for ISO & non-ISO formats up to 8 Mbps
    • Cold start capable FlexRay channels
    • Robust ESD and isolation protection
    • Supports integration with TSMaster for diagnostics and flashing
    Specification Description Specification Description
    Channel 2 x FlexRay / 2 x CAN FD PC End USB 2.0 interface
    CAN/FlexRay End DB9 interface Driver Driver-free design for Windows systems,
    with system compatibility
    FlexRay FlexRay channels (A and B) Cold Startup Supportive
    Buffer Each channel supports a transmit buffer
    of up to 1000 CAN frames    		 CAN Supports CAN 2.0A, B protocols,
    ISO11898-1 compliant,
    baud rate 125Kbps–1Mbps
    CAN FD Supports ISO and non-ISO CAN FD,
    baud rates 125Kbps–8Mbps    		 Timestamp 1μs hardware message timestamp
    CAN Terminal Resistor* Built-in 120-ohm resistor,
    configurable via software    		 FlexRay Terminal Resistor* Built-in 100-ohm resistor,
    configurable via software
    * Single channel at 1 Mbps with a 0-byte data field
    Isolation CAN/FlexRay channel isolated at DC 2500V,
    with ESD protection of ±4KV (contact) / ±8KV (air)
    Power Supply USB powered Casing Material Metal
    Operating Temperature -40℃ to 80℃ Operating Humidity 10% to 90% (non-condensing)
    Operating Environment Keep away from corrosive gases
    • Multi-channel CAN FD and FlexRay analysis
    • Automotive ECU testing and diagnostics
    • Integration in automotive HIL/simulation platforms

    Custom firmware support, diagnostics, and remote configuration available upon request.

    📄 Download Datasheet
    📄 Download User Manual