TTS1018
12 channel CAN FD bus device
The CAN FD1 channel is connected to the board card control bus, allowing direct control of boards within the same bus network through the CAN FD1 channel. The CAN FD1 terminal resistor uses the resistor mounted on the TTS0001 slide rail slot, which is not software controlled. Other parameters are the same as the TOSUN TC1018 device.
With the powerful TSMaster software, it supports loading DBC, ARXML, etc. database files, making it very convenient to monitor, analyze, and simulate CAN FD bus data, and it also supports functions such as UDS diagnostics, ECU flashing, CCP/XCP calibration, etc.
- μs (microsecond) level hardware message timestamps to meet advanced requirements
- CAN channel DC 2500V isolation
- Supports blf and asc format data recording and offline/online playback
- Supports UDS diagnostics and CCP/XCP calibration
- Supports UDS based Bootloader flashing
- Auxiliary communication controller, eliminating the need to add extra nodes during cold starts
- Perfectly adapts to FlexRay, CAN/CAN FD bus applications based on TSMaster
- Supports secondary development interfaces for Windows and Linux systems
| Specification | Description | Specification | Description |
|---|---|---|---|
| Channel | 12 x CAN FD | PC Interface | Converted to USB 2.0 via backplane slot |
| Comm. Port Interface | SCSI 37 Pin Interface | Driver | Driver-free design for Windows and Linux systems |
| Buffer | Up to 700 CAN frames/channel | CAN | CAN 2.0A/B, 125 Kbps to 1 Mbps |
| CAN FD | ISO & non-ISO, 125 Kbps to 8 Mbps | Timestamp Accuracy | 1 μs hardware message timestamp |
| Relay Type | Magnetic latching relay | Messages Sent/sec | Up to 20,000 |
| Messages Received/sec | Up to 20,000 | Isolation | CAN channel DC 2500 V |
| Power Supply | USB power supply | Power Consumption | 4.5 W |
| Operating Humidity | 10% to 90% (non-condensing) | Operating Environment | Keep away from corrosive gases |
Custom firmware support, diagnostics, and remote configuration available upon request.