TTS1034
Dual channel CAN FD/FlexRay bus device
The CAN FD 1 channel connects to the board card control bus, allowing direct control of boards within the same bus network through the CAN FD 1 channel. The CAN FD1 terminal resistor uses the resistor mounted on the TTS0001 slide rail slot, which is not software-controllable. Other parameters are the same as the TOSUN TC1034 device.
With the powerful TSMaster software, it supports loading DBC, ARXML, etc. database files, making it very convenient to monitor, analyze, and simulate CAN FD/FlexRay bus data, and it also supports functions such as UDS diagnostics, ECU flashing, CCP/XCP calibration, etc.
FlexRay Functions
- Flexible configuration for communication controller buffer
- Capable to detect empty frame
- Composite communication modes with multiple cycles (cycle multiplexing)
- Supports frame payloads up to 254 bytes
- Supports PDUs
- Start-up monitoring function
- Message recording and replay
- Use 2 FlexRay channels as 2 nodes (parallel)
- μs (microsecond) level hardware message timestamps to meet advanced requirements
- CAN channel DC 2500V isolation
- Supports blf and asc format data recording and offline/online playback
- Supports UDS diagnostics and CCP/XCP calibration
- Supports UDS based Bootloader flashing
- Auxiliary communication controller, eliminating the need to add extra nodes during cold starts
- Perfectly adapts to FlexRay, CAN/CAN FD bus applications based on TSMaster
- Supports secondary development interfaces for Windows and Linux systems
| Specification | Description | Specification | Description |
|---|---|---|---|
| Channel | 2 x CAN FD / 2 x FlexRay | PC Interface | Converted to USB 2.0 via backplane slot |
| Comm. Port Interface | SCSI 26 Pin Interface | Driver | Driver-free for Windows and Linux |
| FlexRay | Channels A and B | Cold Start | Supported |
| Buffer | Up to 1000 CAN frames/channel | CAN | CAN 2.0A/B, 125 Kbps – 1 Mbps |
| CAN FD | ISO/non-ISO, 125 Kbps – 8 Mbps | Timestamp Accuracy | 1 μs hardware message timestamp |
| CAN Terminal | Built-in 120Ω, software configurable | FlexRay Terminal | Built-in 120Ω, software configurable |
| Relay Type | Magnetic latching relay | Sent/sec* | Up to 20,000 |
| Received/sec* | Up to 20,000 | Isolation | DC 2500 V (CAN/FlexRay) |
| Power Supply | USB | Consumption | 3 W |
| Humidity | 10%–90% (non-condensing) | Environment | Keep away from corrosive gases |
Custom firmware support, diagnostics, and remote configuration available upon request.